ZF ZF 45 IV, Operating Instructions Manual

Page: 7 / 26

INTRODUCTION
7 EN 3201.758.001a 2016-02
1 INTRODUCTION
1.1 INTRODUCTION
Notes to application support work of ZF
Propulsion System Competence Centre.
This document is to be intended only as a support material for the design and analysis of the Vessel Designer and Shi-
pyard in their role of unique Responsible of the final performance analysis, design, selection and decisions.
ZF Marine Propulsion System accept no liability for lack of performance for any expressed or unexpressed result..
In no way, this document is to be intended as a performance and/or commercial promise.
ZF Marine Propulsion System keeps the right to modify procedures, shapes, equipment, optionals, material, etc. men-
tioned or shown in the attached figures.
Also, some mentioned equipment might be optional.
The actual scope of supply will be limited to that mentioned in the offers issued by ZF Sales Dept
1.1.1 NOTICE
Read this handbook before proceeding with the installation.
The following symbols are used to highlight important information on technical reliability and safety:
NOTE:
When this symbol is displayed, the text alongside contains important information.
This symbol denotes a procedure that could damage the gearbox or associated equipment if not followed cor-
rectly.
This symbol denotes a procedure that could result in physical injury to the operator or to other persons in the
vicinity if not followed correctly.
CAUTION
DANGER