Page 9
7.5
Control Heads
Refer only to the following Sections that relate to the Control Heads used.
• Mounting
• 400 Series Control Head:
A
Use the template supplied in MMC-280 400 Series Control Head Variations and drill the
screw holes and the corner cutout holes.
B
Saw between the corner cutout holes.
C
Check that the four mounting screws will start into the Control Head.
D
Remove the Control Head.
E
Strip the adhesive cover from the gasket and apply the adhesive side to the console.
• 700 Series Control Head:
A
Use the template supplied in MMC-307 700 Series Standard Control Head Variations
and drill the screw holes and the corner cutout holes.
B
Drill the screw holes and the cable holes.
• MC2000 Series Control Head:
A
Use the template supplied in MMC-329 MC2000 Series Standard Control Head
Variations and drill the screw holes and the corner cutout holes.
B
Saw between the corner cutout holes.
•
Check that the two mounting screws will start into the Control Head
500 Series Control Head
Assembly:
Refer to Installation Manual supplied with the 500 Series Control Head Assembly for installation
instructions.
8
Set Up Procedures
The Station Expander utilizes push buttons in conjunction with Display LED’s to program, adjust,
calibrate and set up the various features. The push buttons also allow you to access and display
information regarding the health of the System.
The following paragraphs explain how to locate and use the push buttons and Display LEDs:
8.1
Station Expander Components Used In Set Up
Figure ENG-283-5: Station Expander Display LED and Arrow Push Buttons
Each Station Expander has a Display LED and Arrow Push Buttons located on the front cover. (Figure ENG-
283-5: Station Expander Display LED and Arrow Push Buttons)
NOTE: Main Processor function should be set to A3-01 to enable station expander.
11573-1_ART
SERIAL
STA. 4
STA. 4
STA. 2
STA. 2
STA. 3
STA. 3
POWER
PART NUMBER
PART NUMBER
SERIAL NUMBER
SERIAL NUMBER
