ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 45 / 160

SET-UP PROCEDURES
Page 37
6.3.12C0 - Clutch Oil Interlock Enabled/Disabled
This adjustment is to be set to Installed only if the optional Clutch Oil
Pressure Switch is being used with this application.
The function of this parameter is to let the Processor know if a Clutch Oil
Pressure Switch is being used or not. The primary function of the switch
is protection of the Clutch Pack. If for any reason full pressure is not
reached or the pressure is lost when Ahead or Astern Gear is commanded,
the throttle will be commanded to Idle. This feature will protect the
Clutch Pack and prevent costly repairs.
The values of this Function are 00 Not-Installed (Default) and 01
Installed.
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
B) Use the Up or Down arrow to scroll to the C0 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Change the Value of the Function.
E) When the value required is displayed, store the value. Refer to Sec-
tion 6.2.
6.3.13C1 - Clutch Oil Interlock Delay
This adjustment is to be used only if the optional Clutch Oil Pressure
Switch is being used with this application.
This function is used in conjunction with Clutch Oil Interlock ( C0 ). The
value entered determines how quickly the system responds to a low gear
oil pressure situation. The System will respond to the low pressure by
reducing the Throttle Command Signal to Idle.
The values of this Function are 00.5 to 10.0 seconds.
Default Value is set to 05.0 second delay.
To change the value:
A) Depress either the Up or Down Arrow to activate the Function
Menu.
Figure 40: C0 Clutch Oil Interlock Set-up Activated
Function Code is blinking