ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 41 / 160

SET-UP PROCEDURES
Page 33
6.3.1 A0 - Processor Identification
In applications where there is more than one screw, the system must have
some way of determining which Processor is where. Every Processor
must have it’s own identifying unique number. At no time can two Pro-
cessors be identified by the same Processor Identification Number.
The values of this Function are 01 (Default Value) and 02.
To change the value:
A) Depress any Arrow Push-Button to stop running center dash lines.
B) The Display should be as shown in Figure 34: This is the first code
on the Function Menu List and the Function Code for Processor
Identification.
C) Activate Set-up Mode. Refer to Section 6.2.
D) Depress either the Up or Down arrows to change the Value of the
Function.
E) When the value required is displayed, store the value. Refer to Sec-
tion 6.2.
6.3.2 A1 - Number of Engines
The total number of screws must be entered into the memory of each of
the Processors. All Processors in an installation must have the same value
entered.
The values of this Function are 01 Single Screw (Default Value) and 02
Twin Screw
To change the value:
A) Depress any Arrow Push-Button to stop running center dash lines.
B) Use the Up or Down arrow to scroll to the
A1 Function Code.
C) Activate Set-up Mode. Refer to Section 6.2.
Figure 34: Display with A0 - Processor Identification Set-up Activated
Figure 35: A1 - Number of Engines Set-up Activated
Function Code is blinking
Function Code is blinking