ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 30 / 160

INSTALLATION
Page 22
5.3.1 Mounting
400 Series Control Head:
A) Use the template supplied in Appendix A.1 and drill the screw
holes and the corner cutout holes.
B) Saw between the corner cutout holes.
C) Check that the four mounting screws will start into the Control
Head.
D) Remove the Control Head.
E) Strip the adhesive cover from the gasket and apply the adhesive
side to the console.
F) See Section 5.3.2 for cable connection at the Control Head.
700 Series Control Head:
A) Refer to Appendix A.1 Control Head Variations Sheet for hole
dimensions.
B) Drill the screw holes and the cable holes.
C) See Section 5.3.2 for cable connection at the Control Head.
MC2000 Series Control Head:
A) Use the template supplied in Appendix A.1 and drill the screw
holes and the corner cutout holes.
B) Saw between the corner cutout holes.
C) Check that the two mounting screws will start into the Control
Head.
D) See Section 5.3.2 for cable connection at the Control Head.
512 Series Control Head Assembly:
A) Refer to MM14334 Installation Manual supplied with the 512 Con-
trol Head Assembly.
5.3.2 Cable Connection
The 400, MC2000, 700 or 512 Style Controls Heads may be used with the
CruiseCommand System. However, the 7-conductor wiring will require a
modification to the Control Head connections of the terminal connected
Control Heads only.
This 7-conductor cable connects the Control Head to the Processor
through an 8 Pin Plug on the Processor end of the cable. In addition to the
7-conductors, the shield wire must also terminate within the CruiseCom-
mand Processor. In order to accommodate these 8 connections, a modifi-
cation to the Control Head wiring must be done: