ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 29 / 160

INSTALLATION
Page 21
E) Repeat for all Processors.
5.2.3 Control Head Harnesses
There are two choices of Control Head Harnesses depending on the type
of Control Head being used with this application.
• Plug at Processor end of harness only. (terminal connection Control
Heads)
• Plug at Processor and Control Head ends. (Plug connection Control
Heads)
The distance of the Control Head from the Processor is limited to the
length of an uninterrupted 7-conductor harness. This cable may never be
spliced.
A) Install the Control Head Wire Harness between each Control Head
and the appropriate Processor.
B) Label each harness at both ends with the station it connects, and
Port, Center, or Starboard for Multi Screw applications.
When installing the harness, support using clamps or straps not more than
18 inches
(0,5m)
apart, unless contained in a conduit. Refer to ABYC Stan-
dard E-9.
Install each harness so it is protected from physical damage.
See Section 5.3.2 for cable connection at the Control Head.
5.2.4 Alarm Circuit (optional)
Refer to Section 9.1 in the Options Section.
5.2.5 Clutch Pressure (optional)
Refer to Section 9.2 in the Options Section.
5.3 C
ONTROL
H
EADS
See Appendix A.1 Control Head Dimensions and Variations for loca-
tion of cutout and mounting holes for the Control Heads used with this
application. Refer only to the following Sections that relate to the
Control Heads used.
CAUTION:The most common source of trouble is loose wiring connections. Verify wiring connec-
tors are properly crimped and cannot be pulled out. Crimps and connections must be
made to the wire, not to the wire insulation. Verify all screwed wire connections are
secure.