ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 24 / 160

PLAN THE INSTALLATION
Page 16
4.0 PLAN THE INSTALLATION
4.1 P
ROCESSOR
(
S
) L
OCATION
Processors are spray proof, but must
not be immersed.
An engine room location of the Pro-
cessor is preferred.
• If the engine room is too small,
locate in any area where it is
accessible for electrical connec-
tions.
Bulkhead mounting preferred for ease
of access for wiring and adjust-
ments.
The Processor can be mounted in any
attitude as long as the LED on the
front cover is readable.
Do not mount the Processor on the
engine, on the transmission, or in
any location that will subject it to
excessive vibration.
Refer to Figure 15: for Processor dimensions.
Locate Processor(s) away from heat sources, such as engine exhaust
manifolds turbochargers. Allow 4 feet
(1,2m)
of clearance, or
more, between the Processor(s) and such heat sources.
Do not mount close to gas engine ignition systems, alternators, or
electric motors. Allow 4 feet
(1,2m)
of clearance between the
Processor and alternators or electric motors.
A threaded hole is provided for connection to the vessel’s bonding
system.
NOTE: ZF Mathers recommends that the control system be installed in accordance with ABYC E-
9 and P24.
NOTE: Read the Warranty in Appendix A.1. Improper mounting location may cancel warranty.
Figure 15: Processor Dimensions
CAUTION: Electro-magnetic fields can influence CruiseCommand’s electronic circuits.