ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 20 / 160

REQUIRED PARTS AND TOOLS
Page 12
3.0 REQUIRED PARTS AND TOOLS
3.1 P
ROCESSOR
One Processor required per engine (refer to the Drawing in Appendix
C.1)
Mounting Hardware is installer supplied.
Operator Manual included with the Processor:
3.2 C
ONTROL
H
EADS
There are two types of Control Head connections available:
• Plug Connected
• Terminal Connected
Refer to Appendix A.1 for Control Head Variations and Dimensions
Sheets for the type of Control Head being used with this System.
One Control Head is required per Station.
Included with the Control Head:
• Gasket
• Terminals
• Mounting screws
• Control Head Dimensions Variations & Installation Sheets
Figure 12: Processor
The Processor receives the variable DC volt-
age from the Control Head(s) and converts
these inputs to the appropriate electronic or
electric outputs at the correct time and
sequence to the Governor and Gear Box. The
information regarding throttle type, throttle/
gear sequencing, etc. are all stored on mem-
ory within the Processor.
NOTE: Retrofit applications may require planning for an adapter pad to cover the old Control
Head cutout. A variety of adapter and cover pads are available from ZF Mathers, LLC.