ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 139 / 160

Throttle Testing TRAIN-157 Rev.B 6/01
Page 42
G)Turn power ‘On’ to the CruiseCommand Processor and take com-
mand at any remote station.
H)Record the DC Voltage at this time. The measurement should be 7
- 9% of the voltage recorded in step F). Refer to Figure 36:. If the
DC Voltage is off slightly, it may be adjusted using the Throttle
Minimum "
E2 " Function.
I) Move the Control Head lever to the Full Throttle position while
depressing the Transfer Button (Throttle Only Mode).
J) The measurement should be 91 - 93% of the voltage recorded in
step F). Refer to Figure 37:. If the voltage is off slightly, it may
be adjusted using the Throttle Maximum "
E3 " Function.
K)Return the Control Head lever to the Neutral/ Idle position and
turn power ‘Off’ to the Processor.
L) Remove the Test Unit and plug the Throttle Harness back into the
Processor’s Throttle Socket.
Figure 37: Dwg 11653-H