ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 120 / 160

TROUBLESHOOTING TRAIN-156 Rev.B 11/01
Page 24
1.8 P
ROBLEM
S
CENARIOS
Table 2: lists the various Error Codes followed by possible causes and
solutions. The Error Message will appear on the appropriate Port or
Starboard side only. These are not the only possible causes for the
Errors Messages listed, just possibilities.
Err
#
Title Description
50 Communication Error Time-
out System 7 Communication with the system has been too long without a Refresh message.
51 Communication Error Time-
out System 8 Communication with the system has been too long without a Refresh message.
52 Communication Error Time-
out System 9 Communication with the system has been too long without a Refresh message.
53 Communication Error Time-
out System 10 Communication with the system has been too long without a Refresh message.
54 Over Voltage Fault The applied battery voltage is above the expected limits for greater than 2 seconds.
55 Under Voltage Fault The applied battery voltage is below the expected limits for greater than 2 seconds.
56 Reset Due to Software
Watchdog The system has had an unexpected Reset, due to a software/ hardware problem.
57 Reset Due to Software Fault The system has had an unexpected Reset, due to a software problem.
58 Reset Due to Hardware
Watchdog The system has had an unexpected Reset, due to a software/ hardware problem.
Table 2: Problem Scenarios
Err
#
Cause Solution
1 a) The Astern Clutch Solenoid is defective.
b) The Clutch Harness is incorrectly wired at the Gear Box. a) Replace the Astern Clutch Solenoid.
b) Properly connect the Clutch Harness to the Astern Solenoid.
2 a) The Astern Clutch Solenoid circuit is Open.
b) The Astern Clutch Solenoid is defective. a) Properly connect the Astern Clutch Solenoid.
b) Replace the Astern Clutch Solenoid.
3 a) The Neutral Solenoid is defective.
b) The Neutral Solenoid is incorrectly wired at the Gear Box. a) Replace the Neutral Solenoid.
b) Properly connect the Neutral Solenoid.
4 a) The Neutral Solenoid circuit is Open.
b) The Neutral Solenoid is defective. a) Properly connect the Neutral Solenoid.
b) Replace the Neutral Solenoid.
5 a) The Ahead Clutch Solenoid Circuit is incorrectly wired at the
Gear Box.
b) The Ahead Clutch Solenoid is defective.
a) Properly connect the Ahead Clutch Solenoid.
b) Replace the Ahead Clutch Solenoid.
6
a) The Ahead Clutch Solenoid Circuit is Open.
b) The Ahead Clutch Solenoid is defective. a) Properly connect the Ahead Clutch Solenoid.
b) Replace the Ahead Clutch Solenoid.
7 a) The Troll On/ Off Solenoid is incorrectly wired at the Gear
Box.
b) The Troll On/ Off Solenoid is defective.
a) Properly connect the Troll On/ Off Solenoid.
b) Replace the Troll On/ Off Solenoid.
Table 1: Error Messages