ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 12 / 160

OPERATION
Page 4
2.4 E
NGINE
S
TART
I
NTERLOCK
The engine start signal is blocked unless the following are true:
• DC power has been turned ON to the Control System.
• A Station has command.
• The Control System is commanding Neutral.
2.5 S
TATION
T
RANSFER
When transferring command from one Station to another:
C) At the Station taking command depress and hold the transfer
button for 1/2 second. (Refer to Figure 3:)
• The red LED indicator will light at the receiving Station’s
Control Head, indicating the Station has taken command.
D)The commanded positions of the Throttle and Clutch will
remain unchanged for one second after the red indicator lights.
This allows the operator time to move the Control Head
lever(s) to a position approximately matching the last Station’s,
which will allow the vessel to maintain the current speed and
direction.
A)Leave the Control Head lever(s) of
the Station-in-Command in any
position.
B)Place the Control Head lever(s) of
the receiving Station in the Neutral
detent position. (refer to Figure 2:)
Figure 2: Remote Stations before Transfer of Command
• The red LED indicator
light will go Off at the
transferring Station’s
Control Head, indicat-
ing the Station no longer
has command.
Figure 3: Remote Station Transfer after Transfer of Command