ZF CruiseCommand 785CE, Installation And Troubleshooting Manual

Page: 116 / 160

TROUBLESHOOTING TRAIN-156 Rev.B 11/01
Page 20
As you can see by the examples, even though the Command Voltages are
different between Examples # 1 & 2, the resulting A/D counts, are the
same because of the different Reference Voltages. This would result in
the Processor commanding the identical outputs (Clutch & Throttle) in
both cases.
A) The A/D count for a specific Control Head’s lever can be seen on
the Processor’s Display by following the steps outlined in Section
1.4.
B) Once the appropriate remote station is reached, ensure that the dis-
played A/D Count represents the Neutral/Idle position (491- 511 A/
D counts). Command will not be accepted unless the Control
Head’s lever is at the Neutral/Idle position.
1.6.2 Remote Station Select
The second required item for taking command is “Station Select” or
depressing of the Transfer Button. The functionality of the Transfer
Button can be tested by depressing the Up or Down Arrow (scroll) Push-
button one more time after showing the four remote stations’ A/D’s. At
this time the Display will look like the Station A/D’s without the decimal
points as shown in Figure 15::
When the Transfer Button is depressed, the 0 which represents that
remote station, will change to a 1 as shown in Figure 16::
Figure 15: Display Station A/D’s no decimal points
Figure 16: Display with Station Transfer Button pushed