ZETRON 4000 Series, Installation Manual

Page: 48 / 418

Common Control Equipment Installation
48 025-9533Y
Configuring Channel Cards
You can configure each Dual Channel Card (DCC) installed into the channel cardcage to
meet the requirements of the channel pairs. Card configuration is typically not performed
at the Zetron factory, so even if the system has been assembled and programmed by
Zetron, you need to configure the cards.
Label each card with your names for Channel “A” and Channel “B”. When you finish
configuring the cards, place the cards in the slots they came from. This will prevent
conflicting configurations.
The DCCs have several jumpers and switch-selectable options. Table 12 shows the
options. Each type of channel card may have different designators for jumpers and
switches.
The DCC configuration switches are located at the bottom of the legend plate. The
switches are labeled “CONFIG” (see Table 13 ). There are eight switches. The top four are
labeled “CHAN B” and the bottom four are labeled “CHAN A”.
Table 12: Dual Channel Card Configuration Selections
Note To configure a Dual Channel Wireless Control Card (P/N 950-0015),
used for Tait T2030, T2035, T2040, or TM-8255 series
radios ; Zetron Model 427 dispatcher ports ; or Motorola
GM1200 and GM1200E radios
, see
MAP27 Wireless Interface
Option on page 111.
Note
To configure a Dual Channel Wireless Control Card (P/N 950-9867),
used for Harris M7100, Jaguar 725M, or an Orion radio , see
Orion Dual Channel Wireless Control Card Configuration
on page
133.
Note
To configure a Dual Channel Wireless Control Card (P/N 905-0372)
for Harris M7300 series radios , see Series 4000 Installation Kit
for Harris M7300 Radios
(P/N 011-0828).
Option Selection Device
Line Termination Jumper
Channel Cross-Mute Switch
Call Source Jumper
Busy Transmit Inhibit Switch
Duplex Switch
High-Level-Guard-Tone Duration Switch (Tone and T/R control only)
Transmit Audio Record
Jumper