ZETRON 4000 Series, Installation Manual

Page: 306 / 418

IntegratorRDPS Programming
306 025-9533Y
For systems that may include only a handset microphone, you may select “Hookswitch
steering.” See Table 105 and Table 106 .
Table 105: Microphone Source Look-up Table (Hookswitch Controlled)
Table 106: Receive Audio Output Look-up Table (Hookswitch Controlled)
Alert Types
For each console Alert button, you may specify one of six different tone options. The tone
options are: 1 kHz Beep, 1 kHz Tone, Fast Siren, Slow Siren, Warble, and M25 Warble.
MIC Delay Eliminator
This selection enables the PTT delay after the transmit button is released. Select “Yes” or
“No” to enable or disable the PTT delay.
Parallel Status
Enabling the Parallel Status option allows Tone and DC control remote status from other
positions to be reflected at this position. For example, if position 1 sets the frequency on
channel 2 to F3, then the remaining positions (parallel status enabled) display and set the
frequency to F3.
Select “Yes” to enable parallel status reporting. Select “No” to disable parallel status
reporting.
Numeric Keypad
This selection enables the 10-key keypad to be used for number entry. Select “ Yes ” or
“ No ” to enable or disable the number entry. If the “ Numeric Keypad ” feature is
“Enabled” in RDPS, then the “ Home ”, “ End ”, left-arrow (  ), and right-arrow (  )
functions are not available.
PTT SWITCH HEADSET JACK HANDSET MIC SOURCE
D.PTT (do not care) (do not care) D.MIC
E.PTT Plugged in On-hook D.MIC
Removed Off-hook E.MIC
X.PTT Plugged in On-hook D.MIC
Removed Off-hook E.MIC
HANDSET RX AUDIO
On-hook SPKR
Off-hook HDST