ZETRON 4000 Series, Installation Manual

Page: 274 / 418

IntegratorRDPS Programming
274 025-9533Y
Retry Time
The time between sending an MDC1200 message and re-sending the message if
no acknowledgement or response is received. Retry Time can be programmed
from 1 to 15.5 seconds in 0.5-second intervals. A random value between 0 and
1.8 seconds is always added to this value to prevent collisions.
TX Hold Time
The delay after the end of the MDC1200 data before the transmitter is unkeyed.
TX Pre Time
The delay after the transmitter has been keyed before the MDC1200 data is
sent.
Channel ID
Regardless of the type of the call being transmitted, individual or group call, the
individual ID is included as the source ID by the channel card when
transmitting an MDC-1200 message.
Do not configure the individual ID of the channel card to the same ID used by
another field radio. The channel card will ignore incoming calls from its own
ID.
The Group ID is used for decoding incoming group calls.
Emergency
With
Emergency Ack
enabled, the channel card automatically sends an
emergency acknowledge upon receiving an emergency alert.
With
Emergency Tone enabled, the workstation provides an audio feed back
upon receiving an emergency alert.
The
Aux Output Number
is the output activated upon receiving an emergency
alert.
Call Alert
With
Call Alert Response
enabled, the channel card sends an automatic
response upon receiving a call alert.
With
Call Alert Beep the workstation provides an audio feed back upon
receiving a call alert.
Call Alert with Voice
enables/disables voice reception after receiving a call
alert.
The
Call Alert Aux Output Number is the output activated upon receiving a
call alert.
Selective Call With Selective Call Beep enabled, the workstation provides an audio feed back
upon receiving a selective call.
The
Selective Call Auxiliary Output
is the output activated upon receiving a
selective call.
Voice Delay
This selection enables/disables voice delay in the channel card.
Squelch Signaling
This selection enables/disables squelch signaling in the channel card.
Busy Channel Lockout
This selection enables/disables busy channel lockout in the channel card.
Status Request Response
When active the channel card sends an automatic response upon receiving a
status request.
Radio Check Response
When active the channel card sends an automatic response upon receiving a
radio check.
Radio Enable/Disable
When active this selection allows a user at another radio or console to enable or
disable the console from accessing the radio attached to this channel card.
Parameter/Area Purpose