ZETRON 4000 Series, Installation Manual

Page: 134 / 418

Wireless Interface Options
134 025-9533Y
Table 56: Channel options for earlier firmware versions (current version does not require
setting)
Programming the Dual Channel Wireless Control Card
This programming section is for the Dual Channel Wireless Control Card (P/N 950-9867)
only. The Dual Channel Wireless Control Card is used for systems with a Harris M7100,
Jaguar 725M, or an Orion radio.

To configure the Dual Channel Wireless Control Card
1. Use a terminal set for 19200, 8, N, 1 (with no flow control) to connect to the
monitoring port on the front panel using the Zetron cable P/N 709-7452.
2. Once connected, press Esc to get the following menu (the version number may
vary, and your options may vary based on your version):
Orion v1.24.01, 2013-MAR-24
---Press <ESC> anytime to return to this menu---
?,Config : ?
3. Menu choices are activated by pressing the appropriate capitalized letter. You can
press Esc at any time to return to the main menu. Typing a question mark "?" gives
you the current configuration that should look something like this sample:
DCC Serial_No:: 0000B4F6
--- 4048 ChA/B number = 3/4
Active ChA config. ________
Ch Type = Orion
Diag. Log Disabled
Radio Volume=100%
VOX Enabled
VOX Threshold=-18dB
VOX Decay Time=0.5sec
Active ChB config. ________
Ch Type = Orion
Diag. Log Disabled
Radio Volume=100%
VOX Enabled
VOX Threshold=-18dB
VOX Decay Time=0.5sec
AudioDRAM installed = None or Bad.
---Press <ESC> anytime to return to this menu---
Channel Switch Label Type of Selection
B
1 BTI Not used, set OFF
2 OPT (upper) TX blocking, set OFF
3 OPT (lower) Not used, set OFF
4 FD Full Duplex, set ON
A
5 BTI Not used, set OFF
6 OPT (upper) TX blocking, set OFF
7 OPT (lower) Not used, set OFF
8 FD Full Duplex, set ON
Note
For programming Universal cards (P/N 950-9819) and Tone/Local
cards (P/N 950-9820), see Configuring Channel Cards on page 48.