Zeta OPZ1ZT92, Quick Start Manual

Page: 12 / 15

OPZ1ZT92
12
7. Use of Device
7.1. Steps for usage

Place the device within the coverage of the ZETA network

Install the battery, and wait for the device to go online.

After the device is online, the current device status is reported.

According to the usage scenario, set the policy configuration such as
alarm enable status and alarm threshold.

Daily maintenance and data viewing.
7.2. Support function

Version number: Report the software version number of the sensor
only once after power-on.

Status report: Report status data periodically according to the setting.

Set/Query report heartbeat period: can set or query the heartbeat
report cycle. (Range: 1~65535 min, default: 2*60min)

Set/Query report alarm period: When the detected temperature and
humidity exceeds the set threshold, the alarm will be reported on the
set period. (Range: 0-255 minutes, default value: 0, which means the
alarm is reported only once.)

Set/Query Alarm Threshold: Set the upper lower alarm threshold for
alarms. Once the detected value exceeds the set alarm threshold, the
device will report the alarm immediately. (Range: 0-1677721.4, unit
0.1lux, value is 0xFF 0xFF 0xFF means no such threshold is set, please
note that the lower threshold should be lower than the upper
threshold during setting)

Set/Query the alarm release threshold: Avoid repeated alarms caused
by fluctuations of the detected value. Generally, the default value is
used, and no setting is required.

Set/Query alarm enable: Enable ON means that the alarm status needs
to be reported when the threshold is exceeded. Enable Off means no
alarm is required even if the threshold is exceeded.

Set/Query acquisition period: The period of which the device collects
sensor information (range: 0-65535 seconds, when the value is 0, it
means real-time acquisition).

Query status: Actively query the current status of the device, including