ENGLISH
Page
2
of
4
•
All components and instruments are supplied NON-STERILE.
•
Check instruments for damaged surfaces, chipped off edges, deformations and eliminate
damaged instruments. Products that are still contaminated need to be cleaned and disinfected
until all visible contaminants have been removed.
•
Arrange the cleaned and disinfected instruments in the dedicated bur block. Wrap the bur block
using disposable sterilization packaging and/or sterilization containers. Sterilize the assembled
bur block according to the parameters listed in the following table:
Gravity Autoclave
Pre-Vacuum Autoclave
Temperature
132°C
132°C
Exposure Time
25 minutes
4 minutes
Dry Time
30 minutes
20 minutes
WARNINGS AND PRECAUTIONS
•
The use of this or any dental restorative product requires that the clinician and other specialists be
thoroughly familiar with the use and application of these instruments. They must also be familiar
with the instruments and kit sterilization requirements.
•
Care should be taken in choosing the operating speed and force applied to instrument during use to
avoid damaging the instrument or work piece due to excessive heat generation.
•
Improper use of instruments may contribute to premature wear of the instruments, lead to poor
results and pose a danger to the operator.
•
The Polisher is for single use only in cases where residual blood and/or saliva are present.
•
The Kit and individual instruments are packaged NON-STERILE and MUST BE properly cleaned,
disinfected, and sterilized per instructions below prior to use.
•
Refer and strictly adhere to the manufacturers’ instructions for use for the reaction time and
suitability of disinfectants and detergents.
DIRECTIONS FOR USE - DENTURE PREPARATION PROCEDURES
The steps below are guidelines to help process the dentures for implant-retained restorations:
1.
Use the Recess Bur to create a void in the denture. Use the indicators on the bur as shown below
to create the proper recess depth for the LOCATOR and SATURNO Cap.
2.
It is recommended that you use the Undercut Bur to create an undercut in the recess which
enhances the mechanical retention of the pick-up material to the prosthesis. The Undercut Bur
can also be used to create additional clearance in the recess, if needed.
3.
Use the Vent Bur to create a small hole through the denture recess, which enables the visibility of
the Denture Cap and allows for excess pick-up material to flow out.
4.
Use the Trim Bur to carefully trim the flanges and any rough edges on the denture, if needed.
5.
Use the Grind Bur to carefully trim around the attachment pick-up material, if needed.
