Rabbit Hutch 1.8m is now complete.
1.
Fix Back Panel A to Side Panels B using 6no 50mm Screws, 3no per side (Figs.1a & 1b)
2.
Fix Front Panel C to Side Panels B using 6no 50mm Screws, 3no per side (Figs.2a &
2b)
3.
Attach Small Floor Panel D to Back Panel A, Front Panel C and Side Panel B using 8no
30mm Screws - 3no into each of the Back and Front Panel A and C and 2no into Side
Panel B (Fig.3a).
Attach Large Floor Panel E to Back Panel A and Front Panel C using 6no 30mm Screws
– 2no into Back Panel A and 4no into Front Panel C (Fig.3b).
With the assembly laid on its back and the entry ramp fully opened, further attach Large
Floor Panel E to Side Panel B using 3no 50mm Screws as shown in Fig.3c.
4.
Fix 8no Braces F as shown in Fig.4 using 16no 50mm Screws
– 2no per Brace F.
5.
Attach Internal Panel G to battens of Back Panel A and Front Panel C as shown in
Fig.5a using 6no 50mm Screws
– 3no into each panel.
Further attach Internal Panel G to Floor Panel E using 2no 40mm Screws (Fig.5b).
6.
Position Roof Panel H centrally over assembly and attach using 12no 40mm Screws
–
4no into each of the Back and Front Panel A and C and 2no into each Side Panel B.
7.
Lay down 2 pieces of Felt J (Fig.7a) and fold so they interlock as shown in Fig.7b. Apply
tape to the lower piece of felt, remove the top strip and firmly press down the fold as
shown in Fig.7c.
Fix Felt J to the Roof Panel H using 50no equally spaced Felt Nails
– 6no through the
middle fold and 44no around the sides as shown in Fig.7d.
8.
Attach Front and Back Fascias K to Roof Panel H using 14no 40mm Screws
– 7no per
Fascia K (Fig.8)
Attach Side Fascias L to Roof Panel H using 6no 40mm Screws
– 3no per Fascia L
(Fig.8)
Rabbit Run
– Optional Extra
9.
With the assembly up side down Place Rabbit Run Back Panel M between legs of Side
Panels B and fix in position using 8no 50mm Screws
– 2no into each leg and 4no into
Back Panel A (Figs.9a & 9b).
10. Place Rabbit Run Side Panels N between legs of Side Panels B and fix in position using
12no 50mm Screws
– 2no per Side Panel B (Fig.10a) and 2no per leg of Side Panel B
(Fig.10b).
11. Place Rabbit Run Front Panel O between legs of Side Panels B and fix in position using
8no 50mm Screws
– 2no into each leg and 4no into Front Panel C (Figs.11a & 11b).
