Please take a few moments to check all pack contents listed.
Assembly requires 2 persons.
Tools required: Corded/Cordless Drill, Pozi-drive Bit/Screwdriver, 3mm Drill Bit
required in order for you to drill all screw holes before construction.
Large Log Store with Back is now complete.
1.
Position Part A on a flat surface. Position Part B1 with the lowest angle to the
back ensuring board overlaps base and fix using 4no 60mm screws. Repeat on
opposite side with Part B2. (See Fig. 1)
2.
Position Part C1 to the back of Part A ensuring board overlaps base. Fix using
4no 50mm screws (2no per end). (See Fig. 2)
3.
Position Part C2 above Part C1 and fix using 4no 50mm screws (2no per end)
and a further 2no 30mm screws into each support slat of Part C1. (See Figs. 3a &
3b)
4.
Place Part D onto assembly and fix in place using 4no 50mm screws. (See Figs.
4a, 4b & 4c)
5.
Position Part E to front of assembly underneath Part A and fix using 4no 50mm
screws. (See Fig. 5)
