Hanging Flower Bell Assembly Instructions
N.B.
All screw holes
must
be predrilled.
It is recommended that elements A1 & A2 of this product be soaked in water for 2
hours prior to assembly.
1.
Position Long and Short Laths A1 & A2 alternately around Base B (Fig.1a), slide on
Collar C and fix laths in position using 8no Pins
– 1no per lath (Fig.1b).
Fix Collar C in position using 4no 30mm Screws (Fig.1c).
2.
Assemble Ring Sections D as shown in Fig.2a to form a ring, ensuring slots are
outermost (Fig.2b). Fully tighten nuts at this stage.
3.
Position ring assembly as shown in Fig.3.
4.
Bring Laths A1 together around Finial E (Fig.4a), secure in position using Collar C
and 4no 30mm Screws (Fig.4b). Further fix Laths A1 using 4no Pins (Fig.4c)
5.
Insert Screw Eye into top of Finial E (Fig.5)
Assembly requires 2 persons.
Tools required: Corded/Cordless Drill, Pozi-drive Bit/Screwdriver, Hammer
. 3mm Drill Bit
required in order for you to drill all screw holes before construction.
Hanging Flower Bell is now complete.
