Please take a few moments to check all pack contents listed.
Please contact “Zest4Leisure” directly if any of the pack contents are damaged
or missing. Contact telephone: 01352 752555 option 1
or email:
Assembly requires 2 persons. All screw holes to be pre-drilled.
Tools required: Corded/Cordless Drill, Pozi-drive Bit/Screwdriver, 3mm Drill Bit,
Tape Measure.
Gloucester Pergola Seat is now complete.
1.
Ensure underside of Seat Supports A are 400mm from base of Post/Trellis
Assemblies and fix in position using 4no 60mm Screws per Seat Support A
(Fig.1a).
Position Back Supports C as shown in Fig.1b and fix using 2no 60mm Screws per
support.
2.
Fix Seat Assembly D to Seat Supports A using 16no 40mm Screws
– 8no per
side (Fig.2a).
Fix Back Assembly D to Back Supports C using 16no 40mm Screws
– 8no per
side (Fig.2b & 2c).
Attach Fascia E to Seat Supports A using 2no 40mm Screws per side and to Seat
Assembly D using 1no 40mm Screw to centre (Fig.2d).
3.
Position Rafters F 155mm from both ends of Rails G and fix using 4no 60mm
Screws - 2 per Rafter (Fig.3a). Space out remaining Rafters F equally (Fig.3b)
and attach using 4no 60mm Screws.
4.
Locate Rail/Rafter Assembly into post slots and fix into position using 2no 60mm
screws per post (Figs.4a & 4b).
5.
Ensure Post/Trellis Assemblies B are perpendicular to Rails G and attach
Bracings H to back posts using 4no 90mm Screws
– 2no per Bracing (Fig.5).
6.
Position Trellis Battens J to front posts and attach using 4no 60mm Screws
– 2no
per batten (Fig.6a)
Fix Trellis Infills K to Trellis Battens J and Rail G using 4no 40mm Screws per
Infill (Fig.6b)
