Zero FX 2015, Owner'S Manual

Page: 81 / 136

General Maintenance
5.9
General Maintenance
Brakes
This section describes how to maintain the brake system
of your Zero FX motorcycle. It covers the ABS (Anti-lock
Brake System), brake pad examples (specific brake pads
for front and rear are shown), and maintaining brake fluid
levels and types for front and rear systems.
Bleeding the Brake System
Your motorcycle is equipped with ABS. You can only bleed
the brake system if fluid still remains in the HCU (Hydraulic
Control Unit).
Bleeding a dry HCU requires an evacuation and fluid fill
machine.
Brake Fluid Level Inspection
CAUTION:
Do not spill brake fluid on painted surfaces; the
finish could be damaged. Spilling brake fluid on the body
panels will cause them to crack. Clean off any brake fluid
spills immediately.
Always place a shop towel under the master cylinder
reservoir prior to removing cover/cap.
Low fluid levels may indicate worn brake pads or a leak in
the hydraulic system. Inspect the brake pads for wear
and/or the hydraulic system for leaks. Use only new DOT 4
brake fluid from a sealed container.
Front Brake
Inspect the level of the front
brake fluid through the sight
glass (C). If the fluid level is
visibly below the low level
indicator (B), brake fluid must
be added. Clean any dirt or
debris from the cover (A)
before opening the reservoir.
Note: The motorcycle should
be in an upright position prior
to checking fluid level.
1. Remove the two Phillips screws securing the cover
onto the reservoir.
2. Add new DOT 4 brake fluid.
3. Inspect the cover seal, ensuring that it is free of any
wear or damage and that it is positioned correctly.
4. Install the cover and tighten the Phillips screws. Torque
to 5 lb in (0.56 Nm)
Zero Owner's Manual (FX).book Page 9 Thursday, April 5, 2018 1:40 PM