Installation & Operation • 11
INSTALLATION & OPERATION
Alternate Bumper Splice & glass Front Splice
Some cases will have the alternate bumper with optional glass front. When joining two of these cases together, special splice pieces will be
). First, hook the bumper splice over the bumper and fasten it under the bumper so it covers the seam. Next, slide the
glass front splice down over the glass fronts and fasten it to the inside of the case.
Drain
). The 1 1/2"
PVC drain outlet is located at the center front of the case behind the kickplate.
The drain line exits the case in the center. The lateral runs of drain pipe should be installed through the bases (
). There is no
room in front of the base for the drain pipe because the kickplate installs directly to the front of the bases.
Install the drain tee to the outlet pipe and a drain trap to the tee. Plug the open end of the tee using the clean-out plug supplied with the drain
trap kit. The drain line must be pitched away from the case. The tee, drain trap, and plug are supplied with the case. The drain trap must be
level. The drain trap should be primed with water after installation. The drain line must be pitched away from the case enough to ensure proper
drainage. Consult your local codes for minimum requirements.
The forward drain section, tee, and “R” trap are shipped loose for field installation.
FIGURE 15: Splices for Optional Glass Front
Alternate Bumper Splice
(fasten in front)
glass Front Splice
(fasten inside case)
FIGURE 16: Drain Access Port
FIGURE 17: Drain Installation
