BUMPER AND KICKPLATE
UNDER CASE RETURN AIR FLOW ASSEMBLY INSTRUCTIONS
To assemble the bumper for under case return air flow (if requested), a spacer (provided) must be inserted between the bumper and
kickplate (
). The spacer is held in place with the standard black assembly screw used to attach the bumper. One
3/8
" spacer is
required at each screw location (2 spacers on a 2-door, 3 spacers on a 3-door, etc.).
1. To ease installation, hook the bumper to the case and position the kickplate. Then pull the bottom edge of the bumper forward,
hold the spacer in place, and then insert the assembly screw through the bumper, spacer, kickplate, bumper bracket and into the
Tinnerman clip.
2. With the spacers in place, air will be allowed to flow between the bumper and kickplate and then underneath the case. The target
airflow rate under the case should be 50 cfm/door.
Note: An optional louvered kickplate is available.
Figure 18: Bumper Air Flow
Bumper and Kickplate • 19
Summary of Contents for 3RMCC30WA
