11
•
Line up the guide pegs on the Rotor Guards with the holes on the arms of
the Rapture
HD
so that the screw in the Rotor Guard matches up with the
screw hole in the Rapture
HD
.
(Refer to Fig 3.5.1)
•
Firmly press the Rotor guard into position inserting one peg at a time.
•
Insert the included screws into the screw holes and use the included
screwdriver tighten the screws making sure not to over tighten.
3.6
REMOTE
CONTROL
•
Connect the Remote Control Battery to the
included Remote Control Battery Charging Cable
and connect the USB end into the included USB
wall charger.
(Refer to Fig 3.6.1)
•
The red light on the Remote Control Battery Charger will turn off once
the battery is fully charged, once charged disconnect the battery form the
charger.
•
Ensure that the Remote Controls’ power switch is in the OFF (Left) position.
•
With the included screwdriver unscrew the battery cover on the rear of the
Remote Control.
•
Remove the Battery Cover.
•
Connect the Battery cable to the power cable inside the Remote Control
battery hatch.
(Refer to Fig 3.6.2)
•
Insert the Remote Control battery into the
battery slot and make sure that the wires are
tucked in to ensure they are not crushed buy
the battery cover.
•
Replace the battery cover making sure not to
over tighten the screw.
4. FLIGHT
SAFETY
Before flying your Rapture
HD
make sure that you are in a safe setting. CASA
restrictions regarding flying drones require the drone be no closer than 5.5kms
from any airport or airfield whilst flying. Drones should also not be flown over
populated areas or any closer than 30 metres from vehicles people or animals.
It is also required that you check your surroundings before taking off making
sure there are no obstacles or dangers in the area, including overhead power
lines and bodies of water. If there are hazards present in your intended area of
flight, please consider an alternative location.
4.1 FLYING YOUR RAPTURE
HD
1.
After installing a fully charged battery into the Rapture
HD
and Remote
Control and conducting a complete check of your surroundings, turn the
Power Switch
(Refer to Fig 2.2.2 on page 8 - number 5)
on the Rapture
HD
to
the ON position.
2.
Once the Rapture
HD
is powered on, the LED lights on the arms should
flash, signalling no connection to the Remote Control. Place the Rapture
HD
on flat ground facing away from you and move back three meters.
*Fig 3.6.1
*Fig 3.6.2
