Zero Motorcycles ZERO FX 2016, Owner'S Manual

Page: 62 / 144

Power Pack and Charging
5.4
Charging the Power Pack
WARNING! Charge the Zero power pack with the Zero
charger or approved Zero accessory chargers.
It is possible for lithium-ion cells to overheat and fail.
Note: Charge the Zero power pack in a location that is
well-ventilated and away from combustible materials. If
charging your Zero motorcycle outdoors, avoid charging in
the rain.
The maximum power pack internal charging temperature is
122°F (50°C). If the power pack’s internal temperature is
over that, it will not accept a charge until it is cooled below
122°F (50°C). Also, if the power pack has just been run
hard, it may internally be above 122°F (50°C), even if the
ambient temperature is lower.
If you experience a power pack that will not take a charge,
you should ensure the internal temperature is below 122°F
(50°C). If the power pack has recently been operating near
maximum output and/or in hot conditions it may not take a
charge, the power pack should cool off and begin taking a
charge in around 30 minutes or less.
The maximum charging temperature cutoff is a power pack
longevity feature. Charging at higher temperatures can
shorten the life of the power pack.
Note: Frequent top off charging is good for the power
pack’s life span, so do not hesitate to charge frequently.
To charge using the standard on-board charging
equipment:
1. Plug the supplied power cord (A) into the on-board
charger connector. Always keep the power cord with
the motorcycle.
2. Always connect the charger to a GROUNDED outlet.
When using an extension cord, avoid excessive voltage
drops by using a grounded, 3-wire, 12-AWG cord no
longer than 25 ft (7.6 m). The charger can be used on
120 V AC or 240 V AC current. The voltage does not
change the amount of time that the motorcycle takes to
charge.
Zero Owner's Manual (FX and FXS).book Page 4 Monday, December 14, 2015 3:02 PM