CHARGE TANK
User Guide
3
If you have any questions, please contact your Zero dealer for proper usage or installation.
87-00069 Rev 01
Using The Charge Tank (cont’d)
To stop charging using the Charge Tank:
1. Unplug the J1772 plug from the motorcycle. If using the European Charge
Tank, disconnect the charging cable from the charge station and secure it in a
motorcycle storage case or backpack. Otherwise, return the charging cable to
the charge station.
NOTE: In Europe, it may be necessary to stop the charge cycle using
the charge station first in order to unlock your Mennekes-to-J1772
charge cable from the charge station. Please refer to instructions
provided by the charge station network provider.
2. Replace the cover over the Charge Tank inlet.
3. The System Warning Indicator will likely flash after the motorcycle is
disconnected if the motorcycle has not completed a full charge cycle reaching
a 100% state of charge. No damage is done to the motorcycle and this
flashing light simply reflects that the motorcycle was not fully charged.
4. Wait approximately 30 seconds or until all lights, including the System
Warning Indicator and the green blinking Charging Indicator, go out on
the motorcycle’s dash. You may hear an audible click of the power pack’s
contactor open during this step.
Figure 4. Charge Tank Inlet Closed
IMPORTANT: Unless your motorcycle is keyed ON prior to connecting a charge station,
the Charge Tank will not work.
