Page 4
7 If the odour persists, contact your dealer or gas supplier immediately.
Do not store or use gasoline or other flammable vapour and liquid in the vicinity of
this or any other appliance.
USER OPERATING INSTRUCTIONS
TO START ELECTRIC OPERATION
1. Make sure that the gas supply to the appliance is turned off.
2. Plug in the electrical plug.
Note: Appliance cannot be run off two heat sources at the same time.
TO START GAS OPERATION
WARNING: ENSURE THAT THE GAS SUPPLY HOSE IS NOT IN
CONTACT WITH OR NEAR THE BURNER BOX.
1.
Make sure that the electrical supply to the appliance is turned off.
2. Open the shut-off valve for the gas bottle or gas installation (check that there is
enough gas).
3. Open flap B.
4. Keep the flame failure device knob (A) pressed in for approximately 10 seconds.
5. strike match and insert into flap hole (B) or push the ignitor located
on the side of the appliance. See figure A.
6. Keep the knob (A) pressed in for a further 10 seconds then release it. If the
flame goes out, repeat steps 4, 5 and 6 until the flame stays alight. The flame
indicator will move and stay in the green if the burner is alight. See figure A
7.
The appliance should be left running for a minimum of 12 hours
before being loaded with products.
Summary of Contents for GEV60
Page 12: ...Made in South Africa Pty Ltd...
