EN
20
10
8
6
7
9
MOTOR INTAKE FILTER
Designed to prevent various particles (from carpets, dust or dirt present
in the air) from reaching the motor. It is also used to filter the motor cooling
air, a function to be found in TUTTOLUXO models.
1. Check that the aspirating filter is clean, and
therefore efficient, at least once a month, if you
use the vacuum cleaner daily.
2. If needed, remove and rinse the aspirating
filter frequently. To remove it, it is necessary to
first take off the tank and so avoid that, on
turning the appliance over, water is spilled
on the motor fan. Find the lower cover and
remove it by undoing the central screw, simply
using your hands or a coin.
Remove the filter (Pict. 6-7-8) and wash it with
water and neutral detergent.
Before using the vacuum cleaner again, it is
important that the filters are dry, so that they can
operate at their best.
Do not leave the motor intake filter to dry on
heaters or radiators!
HEPA FILTER * OPTIONAL
High Efficiency Particulate Air
The HEPA filter technology assures maximum efficiency of 99.97% particle
capture even smaller than 0.3 microns. The HEPA filter also helps to eliminate
micro-organisms in indoor air. (Pict. 9).
In order to keep the filter always clean and ready for maximum performance, it
should be inspected monthly.
TANK LID WITH FLOAT
Also check efficacy of the Safety Float located on the tank lid. If encrusted with
dirt or mould, this may not function correctly (Pict. 10). Check that the float can
move freely within its cage. Rinse the lid with plenty of hot water and neutral
detergent.
To inspect the filter, proceed as for replacing the Polyester Filter
1) Remove the grilled cover on the back of the TUTTOLUXO 6S.
The
HEPA filter is fitted inside. Place the grilled cover on the floor and
extract the filter as shown.
2) Check the filter state; if there are traces of dust or dirt, replace it.
3) Put the new HEPA filter into place and reassemble the cover,
making sure to properly fit the grilled cover hooks onto the slits on the
appliance body. Once the grilled cover is in place, rotate it upwards for the
final fixing with the stopping tongue.
After some periods of use, should the HEPA filter be torn or damaged, it should
be replaced with a new one from a Zepter Service Centre.
