1,
7
2,
8
3,
9
6,
12
4,
10
5,
11
ZHDN 2000/2500
IE-0101
4
At the third lubrication mode,
run down the lift into position as
shown to the left. Lubricate the
points 4 and
10
, respectively 5
and
11
once again.
Start by lubricating the lift in the raised
position. (See image to the left.)
Tilt the platform a bit to avoid pressure
against the body work and lower the lift
until you get to the lubrication points 5
and
11
. Lubricate all lubrication points
thereafter. To access the points 3 and
9
:
Lower the platform so that there is access,
after the other points are lubricated.
Lubrication Points 4 and
10
can be difficult
to access. If so, wait with these points to
the next step.
Run down the lift in the approximate location
shown on the image to the right. Check that
the lubrication points 1 and
7
on the liftarm
are reachable. Otherwise, fine-tune the
platform closure. Lubricate then all points.
Note: Before lubrication of points 3 and
9
:
Tilt down the platform completely.
The lift has twelve lubrication points: two for each cylinder and four on the lift arm:
(See the oval images below with black frames). On these images shows the lubrication
points on the lift’s right side and is represented with black numbers (1-6).
On the left side of the lift are the lubrication points mirrored, and is represented in text and
images below with red numbers (
7-12
). On some early models are the lubrication points
4 and
10
(Tilt cylinder) on the bottom, in this case lubricate them in the first and second
mode.
Tilt cylinder and lift arm
against the support
frame. (Top view).
Lift cylinder against
support frame.
(View from behind.)
Tilt cylinder against
platform (view from
behind with platform
horizontal)
Summary of Contents for ZHD 1500
Page 2: ......
