10
www.zephyronline.com
24” min.
A
B
CAUTION: At least two installers are required
due to the weight and size of the hood.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
!
Cable Lock
Cable Lock
A cable locking connector (not supplied) might be required by local codes.
Check with local requirements and codes, purchase and install appropriate
connector if necessary. (FIG. B)
Installation –
Mounting the Hood
FIG. A
FIG. B
1. Adjust the mounting brackets by loosening (2) pre-installed screws per
bracket.
2. Mount the component box bracket onto the hood with (2) M4 x 8
screws with the component box facing outwards.
3. Measure from the range top to the hood bottom and mark line A
(24” minimum from range top).
4. Mark the center line vertically.
5. Measure 11-3/8” above line A and mark the hood height, line B.
6. Measure 5-1/8” on line B from the C/L and mark the mounting spread.
7. Mark the mounting spread vertically until a cross has been formed to
determine the exact placement of the M6 x 1” screws.
8. Fasten (2) M6 x 1” screws into the studs on line B, but do not fully
tighten them.
NOTE: Wood blocking may need to be added behind the drywall
if no studs are present. Wall anchors may also be used but
check local codes for compliance. Failure to use suitable wall
anchors and screws to hold the weight of the hood could result
in personal injury or damage to the cooking surface or counter.
9. Hang the hood onto the mounting screws and hand tighten each
screw. (FIG. A)
10. Center and attach the duct cover mounting bracket to the wall just
below the ceiling or soffit using (2) M6 x 1” screws.
11. Install the electrical and duct work. Seal the duct work with aluminum
duct tape.
12. Power up the hood and check for leaks around the duct tape.
13. Place the telescopic duct covers onto the hood and extend the inner
(top) duct cover upwards. Secure it to the duct cover bracket using (2)
M4 x 8 screws.
* If using the hood in recirculating mode, you must secure the air
diverter plate onto wall before installing duct work and duct covers.
You will also need to install charcoal filters and brackets. Turn to page
11 for more details.
