Zephyr Tempest I, Use, Care And Installation Manual

Page: 17 / 88

17 Tempest I Use, Care, and Installation Guide
ZEPHYRONLINE.COM
Installation Instructions
Mounting the Hood
For dual blower installation instructions please refer to page 22.
If recirculating range hood refer to the manual included with ZRC-70xxC recirculating kit or on our
website prior to installing hood. Recirculating kit compatible with 650 CFM single internal blower only.
For Mounting Under a Kitchen Cabinet (FIG. B)
1. Select preferred duct location (vertical or
horizontal).
2. Begin installation by removing the baffle filters.
3. Reinforce cabinet with 1” x 2” wood strips
if additional strengthening is required or if
cabinets are framed.
4. Temporarily position the range hood in the
desired mounting location. Measure and
mark the mounting holes, duct and electrical
locations with a pencil.
NOTE:
If using single internal blower a 8” round
duct opening is necessary. If using a dual
internal blower, please refer to page 24 for cut-
out dimensions.
5. Drill/cut out the required openings for duct and
electrical access; make sure the duct opening
is large enough to apply duct tape.
6. Fasten hood onto cabinet with (4) #4 wood
screws provided.
7. Install electrical.
8. Install duct work and duct tape.
9. Reinstall baffle filters.
10. Power up hood and check for leaks around
duct tape.
FIG. B
duct/silver
ta
pe
5. Duct
opening
cutout
3. Add 1x2
wood strips
2. Baffle
filters