5
2
Warning
Always disconnect power before making any adjustments
or service to the machine. Do not operate in the vicinity of
Warnings
Warning
Do Not Run Port-A-Blaster
TM
without water or cleaning
solution. Doing so will damage the pump.
1. Do not run the unit continuously for more than 30 minutes.
This could overheat the pump and motor and damage the equipment.
2. Be sure unit electrical cord is not frayed or damaged.
3. Use only non-corrosive cleaners with this unit. Strong coil cleaners
can damage the pump.
4. Make sure you are in a safe position when using the Port-A-Blaster
TM
5. Check and clean the inlet screen on the suction tube.
Do not remove this screen.
6. Pump operates when trigger sprayer is squeezed and will cycle
OFF when sprayer is not in use.
Operating Instructions (continued)
7. Turn Power on and choose “INDOOR” (low pressure) or “OUTDOOR”
(high Pressure). Squeeze trigger to activate pump. Pump will discharge
air as it primes.
8. The adjustable nozzle can be turned to vary the spray pattern from
a narrow jet to a fan jet. Don not turn the nozzle too far as it will
unscrew from the wand.
9.
IMPORTANT!
Run clean water through the pump after each use if
you were using a coil cleaning detergent. This will rinse the pump of
chemicals and increase life of pump.
11. Disconnect hoses and break down trigger sprayer wand to
store all accessories in the on-board compartment.
