Zephyr Ion, Owner'S Manual

Page: 23 / 31

Liquid Pad
The Zephyr Ion liquid pad facilitates vaporization of the essential oils from the
aromatic plants listed in this manual. The pad is constructed out of tightly bunched
stainless steel wire, which act as a vehicle for essential oils: the stainless steel wire
acts as a framework for essential oils just as plant fibers provide a framework for
aromatic compounds in ground up plant material.
To use the liquid pad, place the basket on a paper towel (to soak up any spilled
essential oil) and then place the liquid pad inside the basket. Using an eyedropper,
drip the essential oil in an evenly distributed manner across the top of the liquid pad.
The liquid pad is designed to hold up to 10 drops of essential oil. For essential oils
with unknown concentrations, only use one drop at first to test. Increase the number
of drops after testing to achieve the desired vapor quality.
To clean the pad, soak it in rubbing alcohol and then rinse it thoroughly. Once the
liquid pad is clean, it can be reused with other suitable essential oils.
WARNING:
Essential oils may be highly concentrated and very small amounts may be
sufficient. We do not recommend inhaling the vaporized aromatic
compounds from essential oils directly, but instead filling the air with them
by running the Zephyr Ion without the mouthpiece and bag attached. Mild
essential oils from suitable aromatic plants may be used with the mouthpiece
and bag; however, always start out with a very small amount and adjust
upward to achieve the proper vapor quality.
Essential oils become more liquid at high temperatures and if too many
drops of oil are used, the oil may drip down into the heating element, which
may result in damage to the device.
Some essential oils may contain alcohol, which is used as a diluting agent
and helps distribute the active ingredients in essential oils evenly throughout
the liquid pad, increasing vapor quality. However, if such essential oils are
used, alcohol should not be inhaled and must be separated from the active
ingredients. To separate the alcohol, put the prepared basket and liquid
filling pad with essential oil into the basket holder and close the Ion's lid. Set
the temperature to 100°F and press the 'Air' button. Let the air flow through
the basket and liquid pad for a few seconds until the alcohol has evaporated
(Alcohol has distinctive smell. When this smell is no longer present, it
indicates that the alcohol has evaporated). Then heat up the Ion and follow