INSTALLATION
INSTALLATION
Mounting the Range Hood
1. Determine and mark the mounting
position of the range hood with a pencil.
2. Cut out the opening where the range
hood will be installed.
3. Cut out wall or ceiling area for clearance
of ductwork. Install ductwork prior to
range hood.
4. Determine location for the power
supply cable. After drilling access hole,
rout the cable into the electrical box
of the range hood. Secure with a cable
lock and connect to range hood
electrical system.
5. Position range hood into location and
ensure spring loaded catch has locked
into position.
6. Fasten wood screws into wood frame
opening
ELECTRICAL
Locking device
Screw in place
Power supply cable
Entry into range hood
Ductwork connection
All Electrical work must by performed by qualified electrician or person with similar technical
know how and background.
For personal safety, remove house fuse or open circuit breaker before beginning installation.
Do not use extension cord or adapter plug with this appliance.
Follow National electrical codes or prevailing local codes and ordinances.
Electrical Supply:
This appliance requires a 120V 60Hz electrical supply., and connected to an individual, properly
grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring
must be 2 wire w/ ground. Please also refer Electrical Diagram labeled on product.
Cable Lock:
A cable locking connector (not
supplied) might also required by
local codes. Check with local
requirements and codes, purchase
and install appropriate connector if
necessary.
Cable Lock
WARNING
INSTALLATION
SPECIFICATIONS
10"
15-1/4"
16-3/16"
33-3/8"
34-3/8"
2"
2-1/4"
34-3/8"
8"
1/2"Elec. K.O.
16-3/16"
C/L
15-3/8”
(cutout)
33-1/2"(cutout)
= cutout dimension
cut out dimension
Tornado 2 unit (AK 8200 SS)
Models: AK 8100 SS, AK 8200 SS
Page 4
Models: AK 8100 SS, AK 8200 SS
Page 5
