HOW TO USE
1.
Before using the heater, make sure that it is on a flat and stable surface. Damage may occur if it is placed on an
incline or decline.
2.
Set all the controls to OFF position and insert the plug into a socket-outlet with well grounded. Be sure that plug fits
firmly.
3.
Rotate the thermostat knob clockwise to MAX position and switch the heater on as follow:
a.
the switch I for low heat;
b.
the switch II for medium heat;
c.
both switches on for high heat.
4.
When your room reaches the desired temperature, now slowly rotate the thermostat knob counter clockwise until the
pilot light goes out. The thermostat can now be left at this setting. As soon as the room temperature has dropped
below the set temperature, the unit will switch itself on automatically until the set temperature has been reached
again. In this way the room temperature remains constant with the most economical use of electricity.
5.
If you want to change the room temperature setting, rotate the thermostat knob clockwise to raise the temperature, or
counter clockwise to lower it.
6.
This heater includes an overheat protection system that shuts off the heater when parts of the heater are getting
excessively hot.
7.
To completely shut the heater off, turn all the controls to OFF, and remove plug from the socket-outlet.
FAN HEATER
If you want to fasten the speed of heating efficiency when you turn on the unit power, you can just push the fan heater
switch “ON”, the room temperature will be raised in high speed. Push the fan heater switch ”OFF”, the fan heater power
will be off immediately.
TIMER
1.
Setting unit timer according to the clock by turn it clockwise (don’t turn it counter
clockwise).
2.
The timer has a small switch, the function is as follow:
a.
I=Unit is always On;
b.
=Timer function is ON
3.
Set the timer to position. There are 96 small plastic pins on the timer, each correspond to 15 minutes interval.
Push outward the pins corresponding to the time you want the heater to turn ON and push inward the pins
corresponding to the time you want the heater to turn OFF.
CAUTION:
A.
Do not use the timer function unattended.
B.
The heater will not operate if timer is set to the position and the pins are not activated according to the times
required.
C.
If the heater looses its electricity supply, e.g. Switched off at the mains socket or in the even of a power failure,
the time should be reset after the power on again.
D.
L’unità non funziona se il timer è impostato in posizione ed i perni non sono sollevati secondo la fascia oraria
desiderata.
4. The pilot light will be on when the timer is set to ON position or the timing function is activated.
