zentesi ZT200, Instruction Manual, Page: 5 / 6

Teflon Tape & Heater Wire Replacement
____________________________________________________________________________________
Please use a Plus screwdriver.
Note:
•
Remove the power plug from the outlet.
•
DO NOT immediately replace after use or when it is hot.
* Small parts are removed and attached during replacement. Please
be careful not to lose them.
Mounting screws x 8 Heater fixing screw× 2
protective seals
× 8
Teflon Tape Replacement
____________________________________________________________________________________
Since Teflon tape is consumed by heat, you are required by law to
replace it.
1. Remove the following:
•
Eight (8) pieces of protective seals at the bottom of
the main unit. (Remove 8 screws with a Plus
screwdriver)
•
The heating time adjustment parts
•
Teflon tape and saute the new Teflon 70 on the
heater line. (Figure 2)
•
Teflon tape from one side so that the tape is not
loose.
Please stick it.
2. Reverse steps from
②
to
①
and install the parts again.
Heat Wire Replacement
____________________________________________________________________________________
1. Disconnect the heater.
2. Remove the following:
•
Handle parts
•
The heater fixing screws x 2 and disconnect it
•
The cable
3. Pull the new heater wire to the original position.
4. Hang and fasten new heater wire with the heater fixing
screw.
5. Fix Teflon tape on the new heater wire.
Note:
•
When replacing the heater wire, replace the Teflon tape at
the same time
•
Continuing to use exhausted Teflon tape may cause the
heater to disconnect.
• Depending on the frequency of use, the heater wire can be
used for 1 to 2 years.
•
Since this machine is an impulse mechanism, there is no
power consumption when not in use.
•
If you do not use the power plug or power switch for a long
time, unplug the machine