• As a suction hose, be sure to use attached
suction hose(nominal diameter 25mm x 3m) or
an equivalent ‘water suction hose’ only.
• Securely connect hoses with attached hose
couplings and clumps.
• If the suction hose connection is loose, or a
packing in hose coupling has been lost or
damaged, air may be sucked into the pump and
interrupt water suction (air lock).
• A strainer shall be placed so that it does not
appear above water level nor suck bottom sand
and mud.
1. Place your pump at nearby water resource
horizontally.
2. Insert attached hose couplings to the suction
hose and discharge hose and tighten them with
clumps.
3. After checking the packing of each hose
coupling, connect the suction hose to a suction
port and the discharge hose to a discharge port.
Discharge port angle can be changed to 3 different
directions. Adjust to your operating condition.
4. Submerge the suction hose strainer in the water.
5. Lay the discharge hose where necessary.
Arrange protective covers if the hose can be
disturbed by foot steps of others.
6. Remove self-suction plug and top up the pump
with water. (F1)
7. Fill up fuel tank with fuel and tighten the tank cap
securely. (F2)
NOTE
IMPORTANT
6. Set up
F1
F2
❲
11
❳
Summary of Contents for PE2500H
Page 2: ......
