GZ400
GB-6
2. Explanation of Symbols on the Machine
The port to refuel “MIX GASOLINE”
Position:
Fuel cap
The port to top up chain oil
Position:
Oil cap
Setting the switch to the “O” position, the engine stops immediately.
Position:
Rear-left of the unit
Starting the engine. If you pull out the choke knob (at the back-right of
the rear handle) to the point of the arrow, you can set the starting mode
as follows:
•
HALF CHOKE – starting mode when the engine is warm.
•
FULL CHOKE – starting mode when the engine is cold.
Position:
Upper-right of the aircleaner cover
The screw under the “H” stamp is The High-speed adjustment screw.
The screw under the “L” stamp is The Slow-speed adjustment screw.
The screw at the left of the “T” stamp is the Idle adjustment screw.
Position:
Left side of the rear handle
Shows the directions that the chain brake is released (white arrow) and
activated (black arrow).
Position:
Front of the chain cover
For safe operation and maintenance, symbols are carved in relief on the
machine.
According to these indications, please be careful not to make any mistake.
