© Zennio Avance y Tecnología S.L.
Ed. 1
For more info
Page
2
/
2
ASSEMBLY OF THE FRAME (MULTIPLE-COLUMN LAYOUT)
1
Please remove the blind panels and the additional
modules. After that, assemble the additional module enclosures
by opening the gaps previously. Then, fix the assembly by using
the supplied parts and screws. Place the metallic parts supplied
with the frame.
2
Place the left assembly correctly levelled on the wall and
drill two holes for the expansive plugs. Recover the cables and
fix the module with the screws (included).
3
Place the right assembly on the wall by using the T-shape
parts. Mark the position of the holes, drill them and afterwards
place an expansive plug inside them.
4
Fix the right assembly to the wall with screws. Make the
connections of the basic unit and prepare the additional
modules. Pass the bus cable through the gaps.
5
Interconnect the additional modules with the bus as
indicated in the schema and then fix the additional modules with
screws.
6
Place the frames and fix them by using the supplied Allen
key.
Note:
it is recommended to install the backplate (ZVP- BP2W2H) if the wall surface irregularity is greater than 0.5mm.
