© Zennio Avance y Tecnología S.L.
Edition 1
Page.
2
/
2
Attaching DALIBOX Interface 64/32 to DIN rail:
DALI OUTPUT SPECIFICATIONS AND CONNECTIONS
CONCEPT
DESCRIPTION
Number of outputs
1
Output type
DALI bus
Output voltage
17VDC SELV
Maximum current per output
128mA
Maximum number of ballasts per output
64
Maximum number of groups per output
32
Maximum length of cable
300m (considering 1.5mm
2
)
Short-circuit protection
YES
Overload protection
YES
Overvoltage protection
YES
Connection method
Screw terminal block
Cable cross-section
0.5 to 4 mm² (26-10 AWG)
EXTERNAL POWER SUPPLY SPECIFICATIONS AND CONNECTIONS
CONCEPT
DESCRIPTION
Fuse protection of
supply to DALI power
source
Voltage
250VAC
Current
4A
Response type
F (Fast acting)
Connection method
Screw terminal block
Cable cross-section
0,5 to 4mm² (26-10AWG)
Figure 2.
Mounting DALIBOX
Interface 64/32 on a DIN rail
110/230V
AC
50/60Hz
Balast
n
(
n
≤64)
Balast 1
Removing DALIBOX Interface 64/32 from DIN rail:
CONNECTION DIAGRAM
SAFETY INSTRUCTIONS
•
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country.
•
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for the entire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
•
The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini-circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
•
The device has a short-circuit protection fuse that, in case of activation, should only be rearmed or replaced by Zennio technical
service.
•
Once the device is installed (in the panel or box), it must not be accessible from outside.
•
Keep the device away from water and do not cover it with clothes, paper or any other material while in use.
•
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructions at
http://zennio.com/weee-regulation.