Zennio Z41 COM, Configuration Manual

Page: 9 / 21

Z41 COM + Zennio GetFace IP Configuration Guide
http://www.zennio.com Tecnical Support : http://support.zennio.com
9
2.2 GETFACE IP CONFIGURATION
By default GetFace IP acquires its IP address by DHCP, but it can be set a static IP
address as well. To change between one mode and another follow the steps below:
1. Connect GetFace IP to the power supply and to the network.
2. After connecting the power supply or after performing a reset and once the video
intercom is fully initialized (wait until lights up permanently), there are 30 seconds of
operation to perform the following actions:
2.1. Press for 5 times the button of the basic
unit: the device announces its IP.
2.2. Press for 15 times the button of the basic
unit: the device will switch between a
dynamic IP (DHCP) and a static IP
configuration.
The default static IP configuration is shown in Figure 5.
Figure 5 GetFace IP - Static IP Configuration by default
It is recommended to set the IP assignment by DHCP (later is possible to change it to a
static IP) to be able to access the web configuration interface.
To access to the configuration interface, enter the video interdom IP in a web browser.
For example: http://192.168.1.100 .
Authentication is required for access to the web interface. By default, it is set to:
Main button