Zennio Z41 COM, Configuration Manual

Page: 4 / 21

Z41 COM + Zennio GetFace IP Configuration Guide
http://www.zennio.com Tecnical Support : http://support.zennio.com
4
1 INTRODUCTION
This document presents an example of basic configuration of the GetFace IP video
intercom together with the indoor unit Z41 COM in a simple installation of a private
home when both devices are in the same network . A compiter conected to the same
network is also required to access to the GetFace IP web interface configuration.
Figure 1 shows an example of installation and IP addresses of each device.
Figure 1 Topology
It should be noted that Z41 COM has two IP addresses:
One for (in the example: 192.168.1.100)

Remote control through Z41 Remote application.

Connection with the NTP server to update date and time.

Firmware updating through Z41 Update.
Another one for the communication with the video intercom. In the example:
192.168.1.101.
In this case only the IP for the video intercom communication needs to be set,
taking into account that it must not be the same as the IP for the remote control.
Z41 COM
GetFace IP
Internet
Router
PC
192.168.1.103
192.168.1.101
192.168.1.100
192.168.1.102