Zennio WinDoor RF, Quick Start Manual, Page: 6 / 11

WinDoor RF / WinDoor RF 915
https://www.zennio.com Technical Support: https://support.zennio.com
6
1.3 DEVICE PROGRAMMING
Once the battery is connected, downloading both the physical address and the
application program will be possible. To do this WinDoor RF must be in
“active ”
state.
As long as there are no open/close events, the WinDoor RF remains in a low
consumption idle state in which it does not respond to orders or reading requests,
therefore, it is necessary to force it out of this idle state in order to perform the
downloading.
WinDoor RF enters the active state for 1 minute in the following cases:
When pressing the programming button.
After power failure. Resetting the device will also cause the programming led
to blink. After this flashing WinDoor RF enters in active state.
Note : If the programming LED does not light up when connecting the battery,
perform a longer power failure (at least 30 seconds) .
After the first window/door closing. The first time the closed window/door
contact is detected since the last reset, there will be several flashes of the
programming LED. After this blinking, WinDoor RF enters in active state.
1.4 START-UP AND POWER LOSS
During the start-up of the device, the programming LED will blink.
After each restart, the status of the window/door will be sent. In addition, if the tamper
and battery alarms are enabled, the status of the 2 alarms will also be sent after the
restart.