Zennio Touch-MyDesign Display One, Manual

Page: 28 / 48

Touch-MyDesign
http://www.zennio.com Technical Support: http://zennioenglish.zendesk.com
28
From the Configuration window it is possible to select (parameter “Function”) the
desired behaviours for the five buttons that constitute the additional button panel,
according to the following list:
Disabled
Temperature Setpoint
1-byte control (unsigned int)
1-byte control (scaling)
Individual buttons :

Disabled

1-bit

1-bit (hold & release)

Scene

1-byte constant (unsigned int)

1-byte constant (scaling)

2-byte constant (unsigned int)

2-byte constant (float)

Dimmer.

Shutter.
Individual indicators (touching the button will have no effect, although the
LEDs will work as binary state indicators).
Regarding the above options, “Individual buttons” permits configuring each of the
additional buttons as an independent control (analogously as with any of the main
buttons), while all the other options are intended to jointly parameterize a certain
functionality that requires the five additional buttons all together.
The parameterization of each of the above alternatives is detailed in Section 3.4.1 and
the subsequent sections.
3.4.1 DISABLED
Disabling the additional button panel from the “Configuration” screen within the
“Additional buttons” tab will cause that none of the additional buttons has functionality.
However, through the “ LED Lighting ” parameter, it is possible to select whether the
corresponding LEDs should always remain in the off state (“Inactive”) or acquire the
“regular” behaviour (“Active”) thus acquiring the “on” light state for some instants after a
button touch, although this will not have a practical consequence.