© Zennio Avance y Tecnología S.L.
Edition 2
Further information
Page 2/2
SAFETY INSTRUCTIONS AND ADDITIONAL NOTES
•
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country.
•
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for th e entire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
•
Once the device is installed (in the panel or box), it must not be accessible from outside.
•
Keep the device away from water (condensation over the device included) and do not cover it with clothes, paper or any other material
while in use.
•
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructi ons at
https://www.zennio.com/en/legal/weee-regulation.
•
This device contains software subject to specific licences. For details, please refer to http://zennio.com/licenses.
EXTERNAL POWER SUPPLY SPECIFICATIONS AND CONNECTIONS
CONCEPT
DESCRIPTION
Voltage
24 VDC
Current
13 mA
Connection method
Screw terminal block (0.4 Nm max.)
Cable cross-section
0.5-2.5 mm² (IEC) / 26-12 AWG (UL)
OUTPUTS SPECIFICATIONS AND CONNECTIONS
CONCEPT
DESCRIPTION
Number of outputs
1
Output type / Disconnection type
Potential-free output through monostable relay / Micro-disconnection
Maximum load per output
1 electric strike
Rated current per output
DC 1.5 A @ 24 VDC (36 W)
Short-circuit protection
NO
Overload protection
NO
Over-voltage protection
NO
Connection method
Screw terminal block (0.4 Nm max.)
Cable cross-section
0.5-2.5 mm² (IEC) / 26-12 AWG (UL)
Maximum response time
10 ms
Mechanical lifetime (min. cycles)
20000000
Electrical lifetime (min. cycles)
100000 @ 3 A / 50000 @ 5 A
⚠
Important notes:
•
To program this device through the KNX bus, the
auxiliary power supply must remain connected
(24 VDC).
•
This device is designed for standard electric strikes
(normally-open circuit, i.e., the lock remains closed in the
absence of current). When using fail-safe electric strikes
(normally-closed circuit, i.e., the lock opens in the
absence of current), a 24 VDC normally-closed relay
between the fail-safe electric strike and the device must
be installed.
•
Please, use this device only to control one electric strike.
Parallel or serial connection of two or more electric
strikes is not allowed.
•
The cable length between the power supply, Securel v3
and the electric strike should be
30 meters
maximum.
SYSTEM CONNECTION DIAGRAM (ACCESS CONTROLLER, SECUREL V3, POWER SUPPLY AND ELECTRIC STRIKE)
Attaching Securel v3 to DIN rail:
Removing Securel v3 from DIN rail:
SECURE ZONE
Access controller
24 VDC Power Supply
24 VDC Electric Strike
Securel v3
