© Zennio Avance y Tecnología S.L.
Edition 2
Further information
Page
1
/
2
MAXinBOX 24
Multifunction actuator with 24 (16A) outputs
ZIO-MB24
Technical Documentation
FEATURES
▪
6 configurable blocks:
o
Shutter channels (up to 12).
o
Individual outputs (up to 24).
o
2-pipe fan coil control (up to 6 fan coils).
▪
Manual output operation with push button and LED status indicator.
▪
Suitable for capacitive loads, maximum
140
μF
.
▪
Possibility of connecting different phases in adjoining outputs.
▪
30 logic functions.
▪
Total data saving on KNX bus failure.
▪
Integrated KNX BCU.
▪
Dimensions 69 x 96 x 210mm (12 DIN units).
▪
DIN rail mounting (EN 50022), through pressure.
▪
Conformity with the CE directives (CE-mark on the right side).
Programming/test button
: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode.
If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED:
programming mode indicator (red). When the device enters the safe mode, it blinks (red) every half second. The manual
mode is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it starts a blue blinking
sequence.
1
. Output
2
. Output status LED
3
. Output control button
4
. Fixing clamp
5
. Programming/Test button
6
. Programming/Test LED
7
. KNX connector
Figure 1.
MAXinBOX 24
GENERAL SPECIFICATIONS
CONCEPT
DESCRIPTION
Type of device
Electric operation control device
KNX
supply
Voltage (typical)
29VDC SELV
Voltage range
21…31VDC
Maximum
consumption
Voltage
mA
mW
29VDC (typical)
3.92
113.68
24VDC
(1)
10
240
Connection type
Typical bus connector TP1 for 0.80mm Ø rigid cable
External power supply
Not required
Operation temperature
0ºC to +45ºC
Storage temperature
-20ºC to +55ºC
Operation humidity
5 to 95% RH (no condensation)
Storage humidity
5 to 95% RH (no condensation)
Complementary characteristics
Class B
Protection class
II
Operation type
Continuous operation
Device action type
Type 1
Electrical stress period
Long
Degree of protection
IP20, clean environment
Installation
Independent device to be mounted inside electrical panels with DIN rail (EN 50022)
Minimum clearances
Not required
Response on KNX bus failure
Data saving according to parameterization
Response on KNX bus restart
Data recovery according to parameterization
Operation indicator
The programming LED indicates programming mode (red) and test mode (green).
Each output LED indicates its status (green)
Weight
700g
PCB CTI index
175V
Housing material
PC FR V0 halogen free
(1)
Maximum consumption in the worst case scenario (KNX Fan-In model)
4
3
7
5
6
1
2
