Zennio KLIC-DD, User Manual, Page: 10 / 28

KLIC-DD
http://www.zennio.com Technical Support: http://support.zennio.com
10
3 ETS PARAMETERIZACION
For starting to parameterize the KLIC-DD interface it is necessary, once the ETS
program has been opened, importing the data base of the product (version 1.5 of the
application program).
Next, the device is added to the project. The configuration process begins by entering
the Parameters tab of the device.
In the following sections there is a detailed explanation about each of the different
functionalities of KLIC-DD in ETS.
3.1 DEFAULT CONFIGURATION
This section shows the default configuration from which the device parameterization
starts.
Figure 3. Default topology in KLIC-DD.
In the default topology window (see Figure 3) appear the communication objects
associated to the sending and reception of the orders for basic control of the A/C unit:
ON/OFF, Temperature, Mode, Fan and Swing.
When entering for the first time to the parameters edition of KLIC-DD, the following
window will be shown: