© Zennio Avance y Tecnología S.L.
Edition 1
Further information
Page
4
/
4
SPECIFICATIONS AND CONNECTIONS OF EXTERNAL POWER SUPPLY
Fuse protection of
supply to power
source
Voltage
250V
Current
10A
Response type
F (Fast acting)
Connection method
Screw terminal block
Cable cross-section
0.5mm² to 4mm² (20-12AWG)
OUTPUT SPECIFICATIONS AND CONECTIONS
Contact type
Solid state switching device
Load protection
Yes; overheating, voltage surge and short-circuit protection
Dropping voltage
Negligible
Connection type
Screw terminal block
Recommended cable section
0.5mm² to 4mm² (20-12AWG)
Cable type
Stranded or solid wire
Response time
Negligible
LOADS AND POWER (@ 25ºC ambient temperature around the device)
230VAC
110-125VAC
RLC
Up to 250W
Up to 200W
CFL and LED
(1)
Up to 250W
Up to 200W
SAFETY INSTRUCTIONS
•
Installation should only be performed by qualified professionals according to the laws and regulations applicable in each country.
•
Do not connect the mains voltage nor any other external voltage to any point of the KNX bus; it would represent a risk for the entire
KNX system. The facility must have enough insulation between the mains (or auxiliary) voltage and the KNX bus or the wires of other
accessories, in case of being installed.
•
The facility must be equipped with a device that ensures the omnipolar sectioning. Installation of a 10A mini-circuit-breaker is
recommended. To prevent accidents, it must remain open in case of manipulation of the device.
•
Once the device is installed (in the panel or box), it must not be accessible from outside.
•
Keep the device away from water and do not cover it with clothes, paper or any other material while in use.
•
The WEEE logo means that this device contains electronic parts and it must be properly disposed of by following the instructions at
http://zennio.com/weee-regulation.
DIMMER OUTPUT WIRING DIAGRAM
(1)
for leading edge, the maximum load could change depending on the load type. Please refer to the link